the New Eight installation (similar - new table set-up)

Download or Print pdf manual

Stacks Image 86941
The New Eight is shipped with flat packaging. All necessary hardwares are installed and adjusted by our factory.
Stacks Image 86943
Step 1

While the product is on its clear packaging, turn the whole product upside down as shown on the photo.
Carefully, break the plastic wrapping. Leave the packaging on the bottom of product to prevent scratches to the acrylic finish.
It is normal (and intentional) to have the wire legs pop-up.
Stacks Image 86990
Step 2

Rotate the Leg far side by it's hinge around 60 degrees, hold steady by one hand.
While on the rotation, use your other hand to push in the end of the leg to its connector. Release the pressure, The leg should snap-in perfectly.

Stacks Image 86992
The leg position after it fit in the connector.
Stacks Image 87009
Step 3

Do the other side with similar way.

Stacks Image 87011
Turn over the product and place the stainless bowls on its opening.
If you are satisfied with our products - Please share your review with others.
This will help us on continuing to make quality products.